Ion Pro Wave / Professional Ion foot bath System

"We love the new Ion Pro Wave! Works great, feel so good after using it!"

The ION PRO WAVE system is a professional ion foot bath. It is the only computer frequency generated ion foot bath in the world with a bandwidth of 800 MHz and a frequency range of 1.5 MHz. All 700 plus computer controlled programs can be run through this system.

Rather than just introducing a straight electrical charge as other ion foot baths, we have developed computer driven frequency programs targeting specific conditions that are introduced through the ionized energy of electrolysis. TrueRife has almost five years of research into the development of our frequency sets.

Other ionic foot baths use a 60 Hz / 12 volt charge through their systems and are not program specific or frequency based devices and should not be compared to the Ion Pro Wave system.

The Ion Pro Wave's Unique Features

1. Computer controlled with over 600 frequency specific programs and software!

                                                 2. Three bright white L.E.D. on the control module to
                                                  light the ion foot bath. BlueRay technology.

                                                 3. A Sylvania control panel digital readout programmable
                                                  timer. This will allow Therapist and users to set in their
                                                  exact session time which will activate the heater and
                                                  lighting. When the lighting turns off this will signal the
                                                  end of session. There is no need to monitor the computer
                                                  software timer.

5. A calibrated titanium heater not exceed 90 degrees fahrenheit. Our research shows that a ambient water temperature of 88-90 degrees yields the most dramatic results from this system. No other ionic system has these specific calibrated settings but the Ion Pro Wave!

Disclaimer!
Due to FDA regulations and various state laws, no medical claims can be made for Ion Pro Technology. All of the information expressed herein must be considered theoretical and unproven and for research purposes only. The statements on this site have not been evaluated by the FDA, and as such, shall not be construed as medical advice, implied or otherwise.
The following information is not intended to diagnose, treat or cure any physical problems or medical conditions.

Blue Ray Technology / Benefits of Blue Light

Blue Light has been demonstrated to be anti-bacterial. For example blue light destroys P.acnes. Two common strains of methicillin-resistant Staphylococcus aureus, commonly known as MRSA, were virtually eradicated in the laboratory by exposing them to the wavelength of blue light, in a process called photo-irradiation.

Some studies suggest that those exposed to blue light experience an increase in melatonin production, increased productivity and a reduction in pain.

The Blue Light generated from the Ion Pro Wave is doing more than simply outputting blue light emissions, it is frequency based output as can be seen during the programs that are pulsed.

Movement of Protons through the Ion Pro Wave / BlueRay Electrolysis System

The Ion Prow Wave system (formerly referred to as Effectrolysis) uses the action of electrolysis to deliver our research frequencies. This approach has at times produced incredible reports by researchers. We have speculated on a number of possible reasons for these reports. The following conclusions are unproven, but may lend insight into what this ion foot bath system may be doing on the molecular level or in this case on the atomic level.

Electrolysis Explained

Electrolysis of water is the decomposition of water (H2O) into oxygen (O2) and hydrogen gas (H2) due to an electric current being passed through the water. The Ion Pro Wave introduces both electrical current and programmed frequencies during sessions.

An electrical power source is connected to two electrodes, or two plates, (typically made from some inert metal such as stainless steel) which are placed in the water. Hydrogen will appear at the cathode (the negatively charged electrode or Top plate in the Ion Pro Wave array where electrons are pumped into the water), and oxygen will appear at the anode (the positively charged electrode or bottom plate in the Ion Pro Wave array.

The bubbling effects of the Ion Pro Wave is the result of Hydrogen being generated at the Cathode or top plate within the Ion Pro Wave internal array. These are clearly observable dissipating from the ion foot bath openings.

Pure water has an electrical conductivity about one millionth that of seawater. It is sped up dramatically by adding an electrolyte (such as a sea salt, ) this is why we add one tablespoons of Sea Salt to the ion foot bath before starting a session.

The Migration of Protons

When the water is supplied at the anode side, it dissociates (definition: to undergo a reversible or temporary breakdown of a molecule into simpler molecules or atoms;) so that protons and electrons migrates to the cathode under the effect of the electric field. The protons are also discharged at the cathode forming neutral hydrogen gas.

By placing a person to ground (either by holding the stainless steel ground tube in the hand or placing the our exclusive Matrix foot plate at the back) while using the Ion Pro Wave array, a person in essence becomes a second cathode or are negatively charged to ground. Positive charge electrons and protons deliver the research frequencies into and through the body to ground.

Proton Properties Theory / Throwing Rocks instead of Grains of Sand

Protons have mass, and this physical property means that protons tend to penetrate tissues without being deflected as much as a beam of electrons. Their weight also makes it possible to control where they release their energy. As the energy of the protons increases, the signal penetrates more deeply. The proton delivers most of its ionizing radiation where it stops or in this case where it finds a resonant frequency match.

                                                  Note Dr. James Bares comments as regards protons possible role in the frequency
                                                  effects:

                                                 "There is one other very important charge carrier in an atom besides an electron.
                                                  Namely a proton. Now a proton technically has a charge equal to and opposite of
                                                  that of an electron. There is something significant about a proton that isn't normally
                                                  considered:

                                                  The proton is 1,836 times as heavy as the electron. What this means is that from an
                                                  energetic standpoint an electron and proton moving at the same speed and
                                                  impacting an object will strike the object with significantly different kinetic energies.

It remains unknown what effects the Ion Pro Waves array are having on the atomic level when a frequency match is achieved through the computer generated programs.   Protons necessary for the proliferation of a bacterium may be rendered dysfunctional with correct frequency application and delivery. Other functions may be stabilized or even normalized using different sequences that are programmed into the sets. Delivered proton energy along with electrons and EMF may also be a deciding factor.

The frequency controlled "proton effects" is an area that may explain why the Ion Pro Wave is the first choice among professionals and home users. The matter of most importance still remains: Positive results!

Ion Pro Wave / Generating Ions

An ion is a charged atom that has gained or lost an electron which creates a magnetic field capable of attaching to and neutralizing oppositely charged particles. These neutralized particles are extracted from the body through the process called osmosis. Osmosis is a scientific term that is used to describe the movement of particles through a membrane from an area of lower concentration to an area of higher concentration. In this case, the higher concentration refers to the ion field that is set up by placing the array into the water while running the unit. Along with this ionization, specific frequencies are introduced.

"..pulsation of the cell's membrane allowed for a process known as "Electroporation" whereby toxic material (including heavy metals) trapped inside the cell could be "electrically pulsated" out." Stuart W. Titus Ph.D.

The Ion Pro Wave module is placed into the water alongside the feet while the power supply delivers a low level DC pulse to the Ion Pro Wave plates. This causes the metals within the system in combination with water and salt to generate charged ions by separating oxygen and hydrogen in the water. These hydrogen bubbles are clearly observable during session. The Ion Pro Wave is also a micro current system.

Technical Information:

Water color change is normal and a result of the plating and components of the water itself. No claims are made by TrueRife that any meaning at all should be attached to water color if it should vary. The color charts provided with the system are for research purposes only. Water color will vary between persons.

The Ion Pro Wave system can be felt, not just seen.
We have incorporated powerful programs into the
system. This is a different energy field then the EM
field produced by gas filled bulbs or current flow
from contact devices.

This system is based on frequency, not just current or voltage. It is
based on the principles of ionic foot bath researchers, but uses a
different approach (resonance), and therefore may achieve entirely
different results.

When you dial up the power control to a com-
fortable level, you will have no doubt that the
system is active.

This system is for research purposes only!

Specifications:
Signal type: D.C. Pulsed Square Wave
Impedance 4 Ohms
Frequency Range 1-1.5MHz
DDS square wave frequency generation
controlled by internal 32 bit processor.
MS-Windows F100 3.0.24 software to control
the F117 from any PC USB port.

Easy software and firmware upgrades
with the click of a mouse!i
SEE:http://truerife.com/TrueRifeScreenshot.html
for information on the software interface!